Glow Plug Light (Diesel) on a Peugeot 108
This is usually informational. Address it at your convenience.
What the Glow Plug Light (Diesel) Means on a Peugeot 108
The glow-plug light on your diesel Peugeot 108 is your cue to wait a couple of seconds before starting in cold weather. A flashing light after the engine is running, however, indicates a fault the ECU wants checked.
How Urgent Is the Glow Plug Light (Diesel)?
How worried should you be? For the Glow Plug Light (Diesel) on a Peugeot 108, the urgency is low. A good rule technicians rely on is 'colour plus behaviour': match the warning colour against how the car is actually performing. If the Peugeot 108 still drives normally and the light is steady, you usually have time to plan a proper diagnosis; if performance drops or the light flashes, err on the side of caution and stop safely.
Common Symptoms Alongside the Glow Plug Light (Diesel)
The Glow Plug Light (Diesel) on your Peugeot 108 is one data point, and the symptoms around it are the rest of the story. Perhaps the engine feels different, a gauge reads unusually, or the car behaves normally but the symbol simply will not clear. Note everything you observe, because the pattern of symptoms on the Peugeot 108 is exactly what turns a vague warning into a specific, fixable diagnosis.
- Light on briefly at cold start (normal)
- Flashing light after warm-up (fault)
- Hard starting when cold
- Rough running or white smoke on cold mornings
What Causes the Glow Plug Light (Diesel) to Come On?
Why did the Glow Plug Light (Diesel) come on in your Peugeot 108? The honest answer is 'it depends', but the possibilities cluster into a recognisable set of causes. Knowing them in advance means you will not be caught off guard by a diagnosis, and it lets you sanity-check any repair quote against what commonly goes wrong on the Peugeot 108.
- Normal pre-heat cycle (steady, brief)
- One or more failed glow plugs
- Glow plug relay fault
- Crankshaft/camshaft sensor issue
- Related engine management fault
How to Fix the Glow Plug Light (Diesel) on a Peugeot 108
To resolve the Glow Plug Light (Diesel) on your Peugeot 108, resist the urge to simply disconnect the battery and hope it stays off. A warning that is cleared without addressing the cause almost always returns. The step-by-step approach below is the same logical order a professional follows on the Peugeot 108: confirm the basics, read the stored codes, then target the actual fault.
- At cold start, wait for the light to go out before cranking
- If it flashes, scan for glow-plug and engine codes
- Test each glow plug for resistance/continuity
- Replace failed plugs (ideally as a set) and check the relay
- Clear codes and confirm easy cold starts
Is It Safe to Drive With the Glow Plug Light (Diesel) On?
Safe-to-drive depends on judgement, and here is the technician's version for a Peugeot 108: respect the colour, respect the behaviour. Given this light's low urgency, treat any red or flashing warning as a stop-now signal. If everything feels normal and the light is amber, a short, cautious drive to a garage is typically fine, provided you do not delay the actual diagnosis.
Diagnostic Trouble Codes Linked to the Glow Plug Light (Diesel)
If you scan a Peugeot 108 showing this light, these are the OBD-II trouble codes most commonly associated with it. The code you actually retrieve is what pinpoints the repair.
| Code | Meaning |
|---|---|
P0335 |
Crankshaft Position Sensor Circuit The crankshaft position sensor signal is faulty, which can cause stalling or a no-start condition. |
Professional Mechanic Tips
Hard cold starts plus a flashing glow-plug light on a diesel Peugeot 108 usually means one or more plugs have failed — replace them as a set for even starting.
Frequently Asked Questions
Why is the Glow Plug Light (Diesel) on in my Peugeot 108?
On a Peugeot 108, the Glow Plug Light (Diesel) comes on because a monitored value crossed a threshold the car considers abnormal. It could be a simple, inexpensive cause or a genuine fault — the only way to be sure is to scan the vehicle and interpret the codes rather than guess from the symbol alone.
Can I keep driving with the Glow Plug Light (Diesel) on?
Short answer: sometimes, but not indefinitely. Given this indicator's low priority, respect the warning colour and the car's behaviour. When in doubt with your Peugeot 108, the safe choice is to stop and have it checked rather than risk further damage.
How much does it cost to fix the Glow Plug Light (Diesel) on a Peugeot 108?
Repair cost for the Glow Plug Light (Diesel) on your Peugeot 108 depends entirely on the root cause. Because the same symbol covers cheap and expensive faults alike, a proper scan-based diagnosis is the best money you can spend — it turns a guess into a precise, fair quote.
Will the Glow Plug Light (Diesel) reset itself on a Peugeot 108?
Sometimes the Glow Plug Light (Diesel) on a Peugeot 108 clears on its own once the condition that triggered it no longer exists — for example after several good drive cycles. More often, though, the light stays on until the underlying fault is repaired and the code is cleared, so treat a self-clearing light as a reason to still investigate.