Glow Plug Light (Diesel) on a Subaru Crosstrek
This is usually informational. Address it at your convenience.
What the Glow Plug Light (Diesel) Means on a Subaru Crosstrek
On a diesel Subaru Crosstrek, the coiled glow-plug light is normal at start-up: it shows the glow plugs are pre-heating the cylinders. You wait for it to go out before cranking. If it flashes after warm-up, it signals a glow-plug or engine management fault.
How Urgent Is the Glow Plug Light (Diesel)?
How worried should you be? For the Glow Plug Light (Diesel) on a Subaru Crosstrek, the urgency is low. A good rule technicians rely on is 'colour plus behaviour': match the warning colour against how the car is actually performing. If the Subaru Crosstrek still drives normally and the light is steady, you usually have time to plan a proper diagnosis; if performance drops or the light flashes, err on the side of caution and stop safely.
Common Symptoms Alongside the Glow Plug Light (Diesel)
Alongside the Glow Plug Light (Diesel), Subaru Crosstrek owners commonly report a handful of related signs. Some are obvious, others easy to miss until you pay attention. Keeping a short mental (or written) log of what the Subaru Crosstrek does when the light is on gives whoever performs the repair a huge head start and can save you money on diagnostic time.
- Light on briefly at cold start (normal)
- Flashing light after warm-up (fault)
- Hard starting when cold
- Rough running or white smoke on cold mornings
What Causes the Glow Plug Light (Diesel) to Come On?
The Glow Plug Light (Diesel) on the Subaru Crosstrek can be triggered by several conditions, and experienced technicians work through them from most to least likely. Some causes are trivial and cost almost nothing to correct, while others require replacing a sensor or component. The list below reflects what actually turns this light on in the real world, so you can gauge whether you are likely facing a quick fix or a workshop visit.
- Normal pre-heat cycle (steady, brief)
- One or more failed glow plugs
- Glow plug relay fault
- Crankshaft/camshaft sensor issue
- Related engine management fault
How to Fix the Glow Plug Light (Diesel) on a Subaru Crosstrek
Fixing the Glow Plug Light (Diesel) on a Subaru Crosstrek is methodical, not mysterious. Start with the quick, no-cost checks, then let the vehicle's own trouble codes guide you toward the specific system at fault. The ordered steps here are designed so that by the time you (or your technician) reach the more involved work, you have already eliminated the easy explanations.
- At cold start, wait for the light to go out before cranking
- If it flashes, scan for glow-plug and engine codes
- Test each glow plug for resistance/continuity
- Replace failed plugs (ideally as a set) and check the relay
- Clear codes and confirm easy cold starts
Is It Safe to Drive With the Glow Plug Light (Diesel) On?
Safe-to-drive depends on judgement, and here is the technician's version for a Subaru Crosstrek: respect the colour, respect the behaviour. Given this light's low urgency, treat any red or flashing warning as a stop-now signal. If everything feels normal and the light is amber, a short, cautious drive to a garage is typically fine, provided you do not delay the actual diagnosis.
Diagnostic Trouble Codes Linked to the Glow Plug Light (Diesel)
If you scan a Subaru Crosstrek showing this light, these are the OBD-II trouble codes most commonly associated with it. The code you actually retrieve is what pinpoints the repair.
| Code | Meaning |
|---|---|
P0335 |
Crankshaft Position Sensor Circuit The crankshaft position sensor signal is faulty, which can cause stalling or a no-start condition. |
Professional Mechanic Tips
Do not ignore a flashing glow light; on many diesels it doubles as a general engine fault warning, so scan it rather than guessing.
Hard cold starts plus a flashing glow-plug light on a diesel Subaru Crosstrek usually means one or more plugs have failed — replace them as a set for even starting.
Frequently Asked Questions
Why is the Glow Plug Light (Diesel) on in my Subaru Crosstrek?
On a Subaru Crosstrek, the Glow Plug Light (Diesel) comes on because a monitored value crossed a threshold the car considers abnormal. It could be a simple, inexpensive cause or a genuine fault — the only way to be sure is to scan the vehicle and interpret the codes rather than guess from the symbol alone.
Can I keep driving with the Glow Plug Light (Diesel) on?
It depends on the urgency (low) and how your Subaru Crosstrek is behaving. If the light is red or flashing, or the car drives differently, stop safely and get help. If it is amber and everything feels normal, you can usually drive to a workshop soon — just do not put off the diagnosis.
How much does it cost to fix the Glow Plug Light (Diesel) on a Subaru Crosstrek?
There is no single price for the Glow Plug Light (Diesel) on a Subaru Crosstrek; it ranges from a no-cost adjustment to a component replacement. The honest way to control cost is to diagnose the exact code before authorising any repair, so you only pay to fix what is actually wrong.
Will the Glow Plug Light (Diesel) reset itself on a Subaru Crosstrek?
Occasionally, yes — a Subaru Crosstrek can extinguish the Glow Plug Light (Diesel) by itself when the monitored value returns to normal. But a light that keeps coming back is a clear sign of an unresolved issue that needs a proper diagnosis rather than repeated resets.